Overclocking and driving hardware to the limit requires being up to date at all times. This results in frequent rebuilds and system modifications which are much easier and quicker with an open Chassis.
Open top-side mounting of the Mainboard ensures maximum accessibility, while long mounting spacers allow clean cable and tubing routing below the Mainboard - a unique feature on the market.
Mounts on the top level allow installation of additional fans as well as stabilization of graphics cards and other expansion cards.
For full utilization of the cable and tubing routing options, multiple openings were integrated between top and bottom level. Round 22mm openings are intended for tubing and smaller cables, oval 22x70mm openings for EATX plugs and cables.
At the bottom level the HDDs, optical drives, PSUs as well as water cooling elements can be installed. The complete lower base plate can be pulled out on rails after removal of four small screws. This comes in very handy during installation of the components.
Radiators
Both left and right side of the benchtable feature mounting holes for radiators. Either a 360mm or 280mm radiator without thickness restrictions can be installed on each side thanks to a freely configurable bottom level.
As the ultimate cooling performance boost, the bottom of the Benchtable is also equipped with mounting holes for a Supernova radiator. When using such a radiator, we recommend using spacers to allow free air circulation.
Pumps
As in the the Phobya WaCoolIT cases, M4 threads for installation of pumps with screws or decoupling elements are integrated into the benchtable.
These mounting threads are not only machined into the bottom plate, but into a separate plate which can be repositioned if needed or even left our completely if not utilized.
Compatible pumps, amongst others, are the Laing DDC, Laing D5, Eheim 1046 (HPPS, Aquastream, Watercool 12V), Eheim 1058, Magicool 12V, Phobya DC 260 & DC400, EK-DCP 2.2 & DCP 4.0.
Reservoirs
Standard solutions such as a Slot-In reservoir can of course be installed in the drive bays. But isn’t a vertical tube reservoir better, allowing easier filling and looking great? Those considerations were also made by Phobya:
Both at the left and right side, the 21cm high benchtable has mounting holes spaced 12cm apart – ideal for installation of tube reservoirs.
The whole benchtable is made from steel and coated with a glossy black powder coat finish, resulting not only in a great looking piece of hardware, but also a very sturdy base for your system.
All edges are cleanly angled and deburred, and even all mounting screws, except the invisible Mainboard mount screws, are black.
Another highlight of this benchtable is the front – Instead of standard buttons respectively switches, two 19mm holes around the Phobya logo can be used to fit buttons to your liking. The 19mm format allows use of many available buttons and switches.
And when you are looking for the best quality at an affordable price, Phobya offers a wide array of suitable buttons and switches
