The Alphacool Repack – Dual Laing D5 – Dual 5.25” bay station is for designed installation in the front of an enclosure.
For mounting two vacant 5.25” drive bays are required. Mounting of the pump(s) can be done individually or in a dual configuration. For both configurations all required material is included.
Dual operation can be configured to couple the pumps serially or for parallel operation. The pumps always draw the coolant from one combined reservoir. For serial operation the front piece, the Plexi reservoir, has to be removed to connect In- and Outlet respectively to bridge them.
Different than standard solutions, where the coolant is guided around many edges and corners, still leaving micro-bubbles in the coolant, this reservoir uses a completely new technology. A new kind of filter is placed in front of both pump inlets, marked with “in” & “out”, eliminating the problem of micro bubbles at the core.
On standard Slot-In reservoirs filling was a hassle: Unscrew, pull out, fill, fixate again. And during filling a third and fourth hand would always come in very handy, as it is always a very difficult operation to fill in the coolant. Enough! The front is equipped with a filling straw which can be released with few turns, and as it is hollow it can be used for filling of the reservoir.
| Model |
| Manufacturer |
Alphacool |
| Model Number |
Repack Dual Laing D5 Reservoir |
| Specification |
| Compatibility |
2 x 5.25" Drive Bays |
| Inlet / Outlet Thread Size |
1/4" |
| Fillport Thread Size |
Front Fillport Included |
| Number of Inlet Outlet Ports |
4 |
| Pump Compatibility |
1 or 2 Laing D5 Pumps |
| Dimensions |
172 x 148 x 84 mm |
| Special Features |
Front Fill Dual Drive Bay Reservoir
Top Mountable 100mm Cathode (cathode not included)
Front Level Measurement Guide
Pre Drilled for 3 and 5mm LEDs (LEDs not included) |
| Package Contents |
1 x Alphacool Reservoir
1 x Pump Blanking Plug
Mounting Screws
Allen Key |
